Traffic System

Decorative & Slip-Resistant Surfacing System

A finish assembly that adds slip resistance, wear protection and a decorative appearance over a waterproofed or prepared surface.

ConcreteExisting membranes (per compatibility)Cementitious surfaces
Request specification Submit a Project
When this system may fit

Is this the right assembly?

  • A finished, slip-resistant appearance is required
  • An existing membrane needs a decorative wear layer
  • Walkways, thresholds or feature areas need differentiation
  • Both grip and aesthetics matter

These are indicators, not a specification. Suitability is confirmed by a project review.

Substrates

ConcreteExisting membranes (per compatibility)Cementitious surfaces

Product families

System at a glance

The assembly, layer by layer

Decorative sealer / finish
Locks in media; UV-stable finish
Decorative / slip media
Broadcast flake or aggregate
Body coat
Receives and holds the media
Primer / prepared base
Prepared surface or existing membrane
Prepared substrate
Sound and clean

Layers shown top (finish) to bottom (substrate). Actual products and build are per specification.

Existing condition

What we assess first

  • Base surface soundness and compatibility
  • Traffic and slip requirements
  • Desired appearance
  • Exposure and UV
Preparation requirements
  • Prepare or confirm the base surface
  • Verify compatibility with any existing membrane
  • Mask and set out feature areas
  • Prime where required
Critical details
  • Edges and transitions
  • Thresholds and drains
  • Colour / flake set-out
  • Terminations
Application sequence

How it goes together

Prepare base

Prepare or confirm the base surface.

Body coat

Apply the body coat to receive media.

Broadcast media

Broadcast decorative / slip media to refusal or rate.

Seal

Apply the sealer / finish to lock in the media.

Approved system build. The specific products, film builds, coverage rates, cure and recoat times and the qualified build-up for the Decorative & Slip-Resistant Surfacing System are confirmed by the current specification and a project review. We publish these values only where supported by the approved product documents — request the specification for your project below.
Performance

What it delivers

  • Slip-resistant, decorative finish
  • Protects the underlying membrane
  • Customisable appearance
Limitations & considerations

Where to take care

  • Requires a compatible, sound base
  • Slip level depends on media and finish choice
  • Weather-dependent cure
Weather & cure conditions
  • Apply within specified conditions
  • Protect from rain and traffic until cured
  • Observe recoat windows
Quality-control checklist
  • Base compatibility confirmed
  • Broadcast rate / coverage checked
  • Sealer coverage verified
  • Slip and appearance inspected
Warranty & qualification

Backed when specified & installed correctly

Warranty coverage for this system depends on specifying it appropriately for the conditions, installation by a qualified installer, and a registered project. Coverage terms are defined by the applicable warranty document.

Warranty Installer Certification

Technical documents

The specification, installation guide and detail drawings for the Decorative & Slip-Resistant Surfacing System are maintained with revision control and available on request.

Request specification Specifications library

Evaluate this system for your project

Share your substrate and conditions for a confirmed recommendation.

Fast Project ReviewQuick turnaround on every request.
Expert RecommendationsThe right system for your conditions.
Dedicated SupportFrom selection to installation.
Submit a Project
Submit a Project