Roofing System

Acrylic Roof-Restoration System

A water-based, reflective acrylic restoration assembly that renews weathered but sound roofs and reduces rooftop heat gain — an alternative to tear-off.

Aged single-ply (per adhesion)MetalModified bitumen / BURPreviously coated roofs (per compatibility)
Request specification Submit a Project
When this system may fit

Is this the right assembly?

  • The existing roof is weathered but structurally sound
  • The roof drains positively without persistent ponding
  • A reflective, lighter-colored finish is desired
  • Extending service life without a full tear-off is the goal

These are indicators, not a specification. Suitability is confirmed by a project review.

Substrates

Aged single-ply (per adhesion)MetalModified bitumen / BURPreviously coated roofs (per compatibility)

Product families

System at a glance

The assembly, layer by layer

Reflective acrylic finish coat
Weather protection and reflectivity
Acrylic base coat(s)
Builds the restoration film
Reinforcement (at details)
Seams, penetrations and repairs
Primer
Matched to the existing surface
Prepared existing roof
Cleaned and repaired

Layers shown top (finish) to bottom (substrate). Actual products and build are per specification.

Existing condition

What we assess first

  • Existing membrane soundness and adhesion
  • Ponding water and drainage
  • Moisture in the assembly
  • Compatibility with existing coatings
Preparation requirements
  • Clean thoroughly per specification
  • Repair seams, splits and failed details
  • Confirm adhesion by testing
  • Prime where required for the surface
Critical details
  • Seams and laps
  • Penetrations and drains
  • Fasteners and seam plates
  • Terminations
Application sequence

How it goes together

Clean & repair

Wash the roof and repair defects and details.

Prime

Prime as required for the existing surface.

Detail

Reinforce seams, penetrations and repairs.

Base & finish coats

Apply base and reflective finish coats at the specified build.

Approved system build. The specific products, film builds, coverage rates, cure and recoat times and the qualified build-up for the Acrylic Roof-Restoration System are confirmed by the current specification and a project review. We publish these values only where supported by the approved product documents — request the specification for your project below.
Performance

What it delivers

  • Reflective, cool-roof finish options
  • Cost-effective service-life extension
  • Water-based, lower-odour application
Limitations & considerations

Where to take care

  • Not intended for roofs with persistent ponding water
  • Requires positive drainage and a sound deck
  • Cure is sensitive to temperature and moisture
Weather & cure conditions
  • Do not apply if rain, dew or freezing is expected before cure
  • Observe minimum temperature and drying conditions
  • Allow full cure of each coat before the next
Quality-control checklist
  • Cleanliness and repairs verified
  • Adhesion confirmed
  • Coverage / film checks per coat
  • Final reflective finish inspected
Warranty & qualification

Backed when specified & installed correctly

Warranty coverage for this system depends on specifying it appropriately for the conditions, installation by a qualified installer, and a registered project. Coverage terms are defined by the applicable warranty document.

Warranty Installer Certification

Technical documents

The specification, installation guide and detail drawings for the Acrylic Roof-Restoration System are maintained with revision control and available on request.

Request specification Specifications library

Evaluate this system for your project

Share your substrate and conditions for a confirmed recommendation.

Fast Project ReviewQuick turnaround on every request.
Expert RecommendationsThe right system for your conditions.
Dedicated SupportFrom selection to installation.
Submit a Project
Submit a Project