Roofing System

Silicone Roof-Restoration System

A moisture-cure silicone restoration assembly with strong weatherability and tolerance of ponding water, used to renew weathered low-slope roofs.

Single-ply (per compatibility)MetalModified bitumen / BURPreviously coated roofs (per compatibility)
Request specification Submit a Project
When this system may fit

Is this the right assembly?

  • The roof has slow drainage or intermittent ponding
  • High-UV exposure calls for long-term weatherability
  • A reflective restoration is preferred over tear-off
  • Future recoating with silicone-compatible products is acceptable

These are indicators, not a specification. Suitability is confirmed by a project review.

Substrates

Single-ply (per compatibility)MetalModified bitumen / BURPreviously coated roofs (per compatibility)

Product families

System at a glance

The assembly, layer by layer

Silicone finish coat
UV, weather and ponding resistance
Silicone base coat
Builds the restoration film
Reinforcement (at details)
Seams and penetrations
Silicone-compatible primer
Matched to the surface
Prepared existing roof
Cleaned and repaired

Layers shown top (finish) to bottom (substrate). Actual products and build are per specification.

Existing condition

What we assess first

  • Existing membrane soundness
  • Ponding and drainage
  • Compatibility of existing coatings with silicone
  • Surface cleanliness and contamination
Preparation requirements
  • Clean thoroughly, removing contaminants that affect silicone adhesion
  • Repair defects and details
  • Confirm adhesion by testing
  • Prime with a silicone-compatible primer where required
Critical details
  • Seams and laps
  • Penetrations and drains
  • Fasteners
  • Terminations
Application sequence

How it goes together

Clean & repair

Wash and repair; remove silicone-incompatible contaminants.

Prime

Prime as required for the surface.

Detail

Reinforce seams and penetrations.

Base & finish coats

Apply silicone coats at the specified film build.

Approved system build. The specific products, film builds, coverage rates, cure and recoat times and the qualified build-up for the Silicone Roof-Restoration System are confirmed by the current specification and a project review. We publish these values only where supported by the approved product documents — request the specification for your project below.
Performance

What it delivers

  • Tolerant of ponding water
  • Strong UV and weather resistance
  • Reflective finish options
Limitations & considerations

Where to take care

  • Requires silicone-compatible recoating in future
  • Adhesion sensitive to surface contamination
  • Weather-dependent cure
Weather & cure conditions
  • Cure depends on atmospheric moisture and temperature
  • Protect from rain until the surface has cured
  • Observe recoat windows
Quality-control checklist
  • Contaminant removal and cleanliness verified
  • Adhesion confirmed
  • Coverage / film checks per coat
  • Final inspection
Warranty & qualification

Backed when specified & installed correctly

Warranty coverage for this system depends on specifying it appropriately for the conditions, installation by a qualified installer, and a registered project. Coverage terms are defined by the applicable warranty document.

Warranty Installer Certification

Technical documents

The specification, installation guide and detail drawings for the Silicone Roof-Restoration System are maintained with revision control and available on request.

Request specification Specifications library

Evaluate this system for your project

Share your substrate and conditions for a confirmed recommendation.

Fast Project ReviewQuick turnaround on every request.
Expert RecommendationsThe right system for your conditions.
Dedicated SupportFrom selection to installation.
Submit a Project
Submit a Project